SP TW 50 BULLET TWEETER 200W RMS (UNIT PRICE)
Pay in easy, interest-free installments with Klarna.
SUPER POWER AUDIODESIGNED IN ITALY
MMXXVI
200 watt RMS.
All the top end, none of the guesswork.
A bullet tweeter built for pressure: 112 dB sensitivity, a 1" titanium voice coil, 200 W RMS and 400 W peak on a nominal 4 ohm load. Sold singly, one piece per price.
Power, measured not promised
PER TWEETER · RMS IS CONTINUOUS POWER, NOT BURST · NOMINAL 4 Ω
Why this tweeter
The number that matters is the continuous one: 200 W RMS on a nominal 4 ohm load. The 400 W MAX figure is a peak, it is not a working power and we do not sell it as one.
Sensitivity is what you actually hear. At 112 dB SPL 1W/1M this tweeter sits on top of the midrange and the sub without asking the amplifier for much.
A 1" titanium voice coil. That is the part that turns watts into pressure, and it is the part that burns if you run a tweeter full range.
The price on this page is for one tweeter. Build a two-way front with two of them, or add a single one to a system that is already there — you decide, without paying for a pair.
Look at it closely
Full specifications and mounting data, straight from the 2026 factory sheet.
⇩ Open the manual (PDF)English · 2026 edition · opens in a new tab
What you receive
The price on this page is for one piece. If you want a full front stage, order two: they ship from the same stock, so left and right match. Packed in the SP Audio box.
In the box: 1 × SP TW 50 bullet tweeter · mounting hardware · SP Audio packaging.
Not included: crossovers, capacitors, speaker cable and brackets — installation materials, chosen for your car.
Technical specifications
| POWER & LOAD | |
|---|---|
| Rated power (RMS) | 200 W |
| Peak power (MAX) | 400 W |
| Rated impedance | 4 ohm |
| ACOUSTIC | |
| Sensitivity | 112 dB SPL 1W/1M |
| Upper frequency limit | 25 kHz |
| MOTOR & MATERIALS | |
| Voice coil diameter | 1" |
| Winding material | Titanium |
| DIMENSIONS & PACKAGING | |
| Sold as | Single unit (1 piece) |
MANUFACTURER’S LABORATORY DATA · PEAK OR “BURST” FIGURES USED IN SOME MARKETS ARE NOT RMS AND ARE NOT LISTED
Complete the system
Before you install it
- Never connect it straight to the amplifier. A tweeter always needs a crossover, or at the very least a capacitor in series. Full range on a tweeter destroys the voice coil in seconds.
- Cross it high, not low. This is a super tweeter: it plays the top of the range and nothing else. The mid-bass belongs to the midrange, the bass to the subwoofer.
- Do not go below 4 ohm per channel. This page is one piece. Two of them in parallel on the same channel give 2 ohm: most amplifiers will heat up or go into protection. One tweeter per channel is the safe way.
- Aim it, and set the gain low. A tweeter like this is directional, so point it at the listener; then bring the level up slowly. Clipping kills tweeters far more often than power does.
Questions installers ask
spaudio@spaudio.it · +39 340 807 8778
Accepted payment methods
Visa · Mastercard · Maestro · American Express · PayPal · Apple Pay · Google Pay · Shop Pay · Klarna
SP Audio — Super Power Audio. Designed in Italy by Audiocar Import & Export SRLS, Milano, official SP Audio distributor for Europe.